5.2.2. Piezoelectric sensor<br>This is the same problem as the inductive sensor solution. It would take two<br>pieces, one on either side of the crane of the screw. Then the sensor would have to be the same size as<br>the layers where it is to sit and hollow. This is because when the screw is pressed out of the shell<br>the movement is not necessarily axial. Therefore, if you do not measure in the centre, you have to<br>measure the entire outer edge around and get some mean displacement that can then be measured. This was nothing.<br>I was able to find it so it's unclear if it's possible to do that.<br>
正在翻译中..